|
|
|
|
|
Topic: Idler wheel for sprint car
|
Email this topic to a friend |
Subscribe to this Topic
| Report this Topic to Moderator
|
|
Page 1 of 1 of 1 replies
|
|
|
|
|
March 10, 2012 at
08:26:37 AM
|
|
|
Joined:
|
07/24/2005
|
|
Posts:
|
45
|
|
|
|
Is anyone building and selling rear wheels with the splines deleted for idler wheels to push the cars around easily?
This was talked about this a couple months ago but I can not locate the post.
Anyone have experience with this concept?
|
|
|
|
|
March 10, 2012 at
12:13:48 PM
|
|
|
Joined:
|
09/03/2010
|
|
Posts:
|
27
|
|
|
Reply to:
Posted By: yardfun on March 10 2012 at 08:26:37 AM
Is anyone building and selling rear wheels with the splines deleted for idler wheels to push the cars around easily?
This was talked about this a couple months ago but I can not locate the post.
Anyone have experience with this concept?
|
Todds Performance in PA makes one. It's a little pricey but nice. I made my own, I basically bored out an old wheel center, put a sleeve in it that would accept a birdcage bearing on either side. I've also seen them done by boring out a wheel center, leaving a shoulder in it then putting a single birdcage bearing in there. The bearing is held in with a snap ring.
|
|
|
