Home | Register | Contact | Verify Email | FAQ |
Blogs | Photo Gallery | Press Release | Results | RacersAuction.com | HoseheadsClassifieds.com
Hoosier Tire Great Plains | Hoosier Mid Atlantic | Racing Warehouse | Precise Racing | Performance Race Parts | Xtreme Race Parts

Welcome Guest. Already registered? Please Login

 

Forum: Sprint Car Tech Talk (go)
Moderators: BigDog


Records per page
 
Topic: Measuring a Kinsler Manifold Email this topic to a friend | Subscribe to this TopicReport this Topic to Moderator
Page 1 of 1   of  1 replies
ccperf
November 12, 2010 at 05:28:24 PM
Joined: 11/12/2010
Posts: 1
Reply
Is it common practice to determine the size of an injector by measuring the bore inside the pinch clamp? The reason I ask is I recently purchased what was claimed to be a 2 5/8 Kinsler from a guy, it turned out to be a 2 1/2. When I called the guy on it and told him it was a 2 1/2 throttle bore and we needed to do something about it He told me he wasn't going to take the manifold back just because I measure it differently than he and his engine builder.


Wesmar
November 12, 2010 at 10:05:26 PM
Joined: 09/29/2005
Posts: 569
Reply

The correct way to measure the size is by taking the tops off and measuring the butterflies. Measuring the size with the tops on will give you a false reading.





Post Reply
You must be logged in to Post a Message.
Not a member register Here.
Already registered? Please Login





If you have a website and would like to set up a forum here at HoseHeadForums.com
please contact us by using the contact link at the top of the page.

© 2017 HoseHeadForums.com Privacy Policy