HoseHeads.com | HoseHeads Classifieds | Racer's Auction
Home | Register | Contact | Verify Email | FAQ |
Blogs | Photo Gallery | Press Release | Results | HoseheadsClassifieds.com


Welcome Guest. Already registered? Please Login

 

Forum: HoseHeads Sprint Car General Forum (go)
Moderators: dirtonly  /  dmantx  /  hosehead


Records per page
 
Topic: Tech Question About Rear Axles and Wheels Email this topic to a friend | Subscribe to this TopicReport this Topic to Moderator
Page 1 of 1   of  0 replies
bigjackhut
July 19, 2015 at 03:09:26 PM
Joined: 10/03/2007
Posts: 19
Reply

Tech question about rear axle spline length and wheel offset for a winged car.

We always have ran long spline rear axles on both the left and right side but I recently ran across several rear ends for sale that are either short spline on both right and left or long spline on right and short spline on left.  All of our RR wheel's are 5, 6, 7 off's and our LR wheel's are all 5 off's.  Can anyone tell me if I would still be able to use the wheel's I have or would I need to buy some 3 and 4 off's to make this work?  On a typical night, we keep our LR in as tight as we can so I think LR we would be ok but I'm not sure on RR?  We typically keep our RR between 16.5" and 18.5" from the outer edge of the top bumper spud to the center of the tire.  Could we get our RR out that far - 18.5"?  And maybe I'm wrong on the LR too, maybe we couldn't get the LR where we need it? 

I know I could probably go out to the shop and figure all this out with a little time but let's face it, it's hot and I'm fat and lazy.  Was hoping to get the answer while chilling in front of the TV Smile






Post Reply
You must be logged in to Post a Message.
Not a member register Here.
Already registered? Please Login





If you have a website and would like to set up a forum here at HoseHeadForums.com
please contact us by using the contact link at the top of the page.

© 2024 HoseHeadForums.com Privacy Policy