|
|
Topic: Right Size Car Tall Driver
|
Email this topic to a friend |
Subscribe to this Topic
| Report this Topic to Moderator
|
Page 1 of 1 of 5 replies
|
|
|
May 02, 2015 at
04:39:29 AM
|
|
Joined:
|
05/02/2015
|
Posts:
|
2
|
|
|
Hi All,
Recently stepped out of Formula 500's here is AUS, (Micro Sprints) and now preparing to have a run at 410's.
I wanted to know what size chassis I should be looking for being 6 foot 6, just to make sure I can adjust for leg room etc, head room should be ok, but I'm mostly legs lol. There seem to be a lot of 88/40 chassis, would this be ok to adjust?
Planning to go into a Maxim chassis.
Any help would be appreciated.
Thanks, Dan.
|
|
|
May 02, 2015 at
05:30:08 AM
|
|
Joined:
|
01/27/2005
|
Posts:
|
411
|
|
|
http://www.racemaxims.com/frames/
You will probably need a big boy chassis beings you are 6'6" tall. They are also a 88/40.
|
|
|
May 02, 2015 at
07:41:00 AM
|
|
Joined:
|
12/01/2004
|
Posts:
|
639
|
|
|
Cool Chassis from Australia are made with 2" more height. Shane Stewart is running them on the Woo trail.
|
|
|
|
May 02, 2015 at
10:51:43 AM
|
|
Joined:
|
04/14/2007
|
Posts:
|
564
|
|
|
My brother is 6'5 with a two inch tall 88/40 J&J and loves it... Has a lot of head room below the top.
Brandon McLain
United Sprint Car Series Driver
2014 Season
National Rookie of the Year!
National Points - 8th
Southern Points - 3rd
Asphalt Points - 3rd
18 Races, 3 Top 5's, 14 Top 10's
|
|
|
May 02, 2015 at
12:06:24 PM
|
|
Joined:
|
09/12/2011
|
Posts:
|
118
|
|
|
I'm 6'4" and very tall in the torso. I had a tall J&J 1" in front and 2" in rear that I fit in, now I have an ex-Dale Blaney GF1.
|
|
|
May 02, 2015 at
05:36:05 PM
|
|
Joined:
|
05/02/2015
|
Posts:
|
2
|
|
|
Thanks for the replies all, gives me a bit of an idea.
Cool chassis were another one I was thinking of so thats good to know, also on the J&J and GF1.
Assuming I picked up a 88/40 maxim standard chassis, is there anythting stopping buyiny a big boy chassis and transferring all the running gear accross? (with regard to fitting issues) if anyone had seen this before, or if not I may email Maxim for an idea.
Thanks again for the comments,
Dan.
|
|