Forum: Racing From The Past (go)
Moderators: Racing From The Past

Topic: TAPERED AXELS

Email this topic to a friend | Subscribe to this Topic | Report this Topic to Moderator

Page 1 of 1 of 0 replies

welder

September 22, 2008 at 02:38:33 PM

Joined:	11/29/2006
Posts:	595

Reply

I am looking for 2 or 3 inch tapered axels, 48 to 52 straight up no offset. Also a champ 12 bolt Alum. center section Halibrand. My E-Mail address is [email protected] Thanks.

Post Reply

You must be logged in to Post a Message.
Not a member register Here.
Already registered? Please Login

If you have a website and would like to set up a forum here at HoseHeadForums.com
please contact us by using the contact link at the top of the page.
© 2025 HoseHeadForums.com Privacy Policy

Forum: Racing From The Past (go) Moderators: Racing From The Past

Forum: Racing From The Past (go)
Moderators: Racing From The Past