Home | Register | Contact | Verify Email | FAQ |
Blogs | Photo Gallery | Press Release | Results | RacersAuction.com | HoseheadsClassifieds.com
Hoosier Tire Great Plains | Hoosier Mid Atlantic | Racing Warehouse | Precise Racing | Performance Race Parts | Xtreme Race Parts

Welcome Guest. Already registered? Please Login

 

Forum: Sprint Car Tech Talk (go)
Moderators: BigDog


Records per page
 
Topic: 400 Cylinder heads Email this topic to a friend | Subscribe to this TopicReport this Topic to Moderator
Page 1 of 1   of  2 replies
oetken
December 23, 2006 at 10:21:06 PM
Joined: 08/16/2006
Posts: 16
Reply

Just a pretty simple question. Will the heads off a 400 Chevy small block fit a 350 block, or does there need to be any machining to make them work.

Thanks in advance.


Davis Oetken


lobo
January 06, 2007 at 09:39:34 PM
Joined: 01/29/2005
Posts: 42
Reply

the heads are interchangable



BigDog
MyWebsite MyResults MyPressRelease MyPhotos MyBlogs
January 17, 2007 at 09:08:42 AM
Joined: 07/01/2006
Posts: 514
Reply

Stock 400 heads are the same casting as 350 heads. At the factory they drill four steam holes in the deck of the head to help try and cool the 400 better. 400 heads can be used on 350 engines with out any problems. If you want to install 350 heads on 400 engines then just drill the steam holes in the heads. Use the 400 gasket as a template so you know where to drill. Make sure you look at a 400 head first so you know the angle at which the holes are drilled in the head.


My Signature



Post Reply
You must be logged in to Post a Message.
Not a member register Here.
Already registered? Please Login





If you have a website and would like to set up a forum here at HoseHeadForums.com
please contact us by using the contact link at the top of the page.

© 2017 HoseHeadForums.com Privacy Policy