The HTC Android Brush Step 1: Brush SPL steps
1: Install Microsoft ActiveSync 4.5.0 Chinese version.
2: the "Artemis_USPL" folder on the root directory of the C drive (system disk)
3: Remove the SIM card and cell phone hard Kai (clear memory).
4: re-boot of the phone plug in the cable connected to the computer, is rigid Kai handset will prompt ActiveSync synchronization wizard, do not sync point cancel.
At this time you should see the ActiveSync display as guests
5: the run Artemis_USPL file folder inside start_uspl.exe (DOS interface first appeared, DOS start loading the installation, this time of the phone do not have any reaction, you do not move it, DOS the top there will be a percentage of the figures, wait for 2-3 minutes it automatically after running DOS the top .... 100, the phone will be black, do not worry).
6: After the completion of the previous operation, the computer will automatically appear RUU Brush program (Note: this is not a brush ROM, brush SPL), this time on the hook, and then all the way to the next step is completed, the computer will appear Finished button, press Finished button end.
Here points "Update"
Note: the phone not finalized Never disconnect the cable, under normal circumstances, the entire process for about 5 minutes or so.
The good brush SPL phone automatically restart If SPL 1.11.0000 on success.
HTC Android Brush Step two: Brush process
1: Make sure that the SPL has been reduced to 1.11.0000, otherwise, do not brush, please go to "Step 1: Brush the USPL step".
2: the decompression will get "RUU" file folder casually on which disk, and from other places to get the ROM file (extension. Nbh) to copy or move to the RUU folder, if the original other. Nbh file , deleted or moved. Brush OS or GSM Wireless module, is a. Nbh file, the operation is the same.
3: Do not pick a data cable, phone off, and then while holding down the record button on the left side and the right side of the switch button, keep a few seconds until the phone is tri-color screen, and then let go. If you press the wrong button causes the phone is switched on, unplug the battery, and restart the operation.
4: Connect the data cable, first into the tri-color screen connected to the computer, the computer will automatically install a driver, a little wait. Tri-color screen lower left of the word "USB" connection is successful.
5: Run RUU.exe the ROMUpdateUtility.exe.
6: check mark in the box inside, all the way to the next step,
Here points "Update"
7: Then computers and mobile phones will be a progress bar, and other computer automatically runs the 100% progress bar appear Click Finished end button, the phone will automatically restart, Brush finished, this time in order to disconnect the cable, please note.
HTC Android Step 3: Brush Brush Important Note
1: Brush back up important data, contacts, SMS, call history, it is recommended to use the smartphone studio backup.
: The best brush machine with a laptop, so you can prevent power outages, the desktop brush to half of a power outage, you can cry. In fact, as long as no situation when lowering the SPL on the line, brush the other does not matter.
3: Brush the process of computer Do not run the program with high CPU usage, making it easy to brush crash, it is best to put off all other software.
4: Be sure to use the Cable For Sony PS3 CONTROLLER PS 3 to synchronize, and do not use Bluetooth, after all, at this stage of the Bluetooth transmission is not 100% reliable, and have seen that in other forums with Bluetooth synchronization bad brush up.
5: cell phone battery will be filled with the best 100%.
6: we must win the SIM card and the memory expansion card (TF card), Brush harden before the best (that is, clear the memory) cell phone.
|
