With the advancement of production technology, thermosetting resins are gradually replaced by photocurable resins. Photocrosslinkable polymers, initiators, and additives. The most essential difference between them and thermosetting resins is that the curing process relies on the absorption of the corresponding wavelength. The chemical reaction caused by light radiation, which causes the photocurable resin to change from liquid to solid. It changes from liquid to solid as a result of molecular weight increase, rather than solvent evaporation, so it has the advantages of rapid curing, no pollution, and energy saving, but the limiting factor is the high price of raw materials. In terms of thin cutting sheets, China has successfully developed ultra-thin diamond high quality cutting disc supplier with a thickness of 0.15mm by using photocurable resin as a bonding agent and successfully completed the cutting test of single crystal silicon wafers. Resin cutting sheets have many advantages, which can greatly improve the efficiency of work and can also save you the cost of production. As a cutting tool, the cutting piece must pay attention to the operating specifications when it is used, otherwise, it will be prone to accidents. So how Can it be used as a specification? Here is a detailed introduction to everyone: When using the cutting piece, the cutting piece is only allowed to be used for single piece installation. It is strictly forbidden to use two or more pieces at the same time; the speed of use cannot exceed the working line speed specified by the trademark of the cutting piece. When using a pneumatic grinding machine, it is necessary to prevent the air pressure from being unstable. The cutting piece exceeds the maximum speed; the storage time is one year. If the time exceeds the time, the rotation test should be carried out again. After confirming the pass, it can be used. When using the cutting piece, it is necessary to make a sudden force. If the force is too strong, it is easy to stop. Jamming and crushing cutting In the case of a film, if the jam occurs, the fiber cutting disc Chinese supplier should be lifted immediately to prevent the cutting piece from burning out or being broken.