|
|
Topic: ? on how to set hydraulic lifters
|
Email this topic to a friend |
Subscribe to this Topic
| Report this Topic to Moderator
|
Page 1 of 1 of 2 replies
|
|
|
June 11, 2009 at
10:16:35 AM
|
|
Joined:
|
02/14/2005
|
Posts:
|
254
|
|
|
I am setting the valves on my 305 which has hydruailic lifters and roller tip rockers.I'm unsure of the "correct" method but what i did is go down the firing order, getting each cylinder at top dead center.I tightened the rockers down just so the roller tips could move across the valve tip.From what I understand, they should be set at 0 valve lash.Can anyone please explain the correct method to adjusting these types of valves? thanks, ron cubic
|
|
|
January 15, 2010 at
12:18:37 AM
|
|
Joined:
|
02/17/2009
|
Posts:
|
202
|
|
|
Reply to:
Posted By: RRC on June 11 2009 at 10:16:35 AM
I am setting the valves on my 305 which has hydruailic lifters and roller tip rockers.I'm unsure of the "correct" method but what i did is go down the firing order, getting each cylinder at top dead center.I tightened the rockers down just so the roller tips could move across the valve tip.From what I understand, they should be set at 0 valve lash.Can anyone please explain the correct method to adjusting these types of valves? thanks, ron cubic
|
wesmar in oklahoma will help if you call them during business hours
|
|
|
January 25, 2010 at
07:54:16 PM
|
|
Joined:
|
09/29/2005
|
Posts:
|
626
|
|
|
Your on the right track. When you tighten it down like you said you were, go a 1/2 turn more and that will be sufficient enough.
|
|